Clipsal 5400 Series Guia do Utilizador descarregar pdf (Página 21)

Clipsal 5400 HomeSafe Security Panel - USER Guide

OPERATING THE 5400 BY TELEPHONE

The 5400 will allow a user to call in to the

panel, using a standard DTMF telephone,

and remotely Arm or Disarm all areas and

also turn on or off Aux 1 and Aux 2.

To ensure security of operation a user can

only carry out remote operations after entering

a valid user code.

WHAT’S NEEDED:

• A telephone with DTMF tones.

• A Valid User code programmed in the

5400.

• The 5400 to be connected (via Mode 3

socket) to a working telephone line at the

installed premises.

• You need to know the telephone number of

the line that the 5400 is connected to.

REMOTE OPERATION

NOTES

• If the 5400 does not receive commands for periods longer than 10 seconds it will

assume that the call is finished and it will hang up.

• If an alarm occurs which requires the 5400 to dial out while attempting remote

control, the 5400 will treat the alarm as a priority, give a constant tone as a warning

and then hang up.

• When all remote control commands are finished press to force the 5400 to

hang up.

SEQUENCE OF OPERATION.

1. Phone the 5400 telephone number and

listen for the required number of rings

(ring ring...ring ring) and then hang up.

2. Wait 10 seconds and then call the number

again within 50 seconds.

3. The 5400 will answer the second call

immediately, sound a beep for 2 seconds

then, after a pause, it will sound a lower

frequency tone. The 5400 is now ready to

receive telephone commands.

4. Press the button on the telephone. This

tells the 5400 that telephone commands

will follow. It will respond with either 3

beeps if all OK (One long beep means try

again).

5. Now enter a valid User Code (that is

normally used for Arming or Disarming the

5400) followed by the button.

The 5400 will respond with 3 beeps if it

recognises the code or 1 long beep to

signal the code was invalid and to try

again.

6. Enter the required command.

See: Summary Of Telephone Commands.

7. Press to finish. This tells the 5400 to

hang up. Also, hang up your telephone.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Comentários a estes Manuais

Sem comentários

Clipsal 5400 Series Guia do Utilizador Página 21

Comentários a estes Manuais