Clipsal C-Bus2 Manual de Serviço descarregar pdf (Página 6)

The Infra-red Output Unit is a C-Bus2 device that allows control of infra-red

products such as A/V components installed in boardrooms, homes, etc. Infra-

red command strings are stored in non-volatile memory that resides within the

C-Bus2 Infra-red Output Unit.

· The C-Bus2 Infra-red Output Unit connects to a C-Bus UTP unshielded

Cat 5 network - no other external power source is required

· The C-Bus2 Infra-red Output Unit module uses any input device connected

to C-Bus to initiate infra-red commands

· Each infra-red channel is software addressable with macro infra-red

commands

· The C-Bus2 Infra-red Output Unit device can store approximately 200

unique infra-red codes

· The C-Bus2 Infra-red Output Unit unit has the capacity for connection of

two 3.5mm mono mini plug emitter cables with single or dual infra-red

emitter(s)

· Any C-Bus2 Group Address can be ‘mapped’ to any combination of the

two infra-red output zones on the C-Bus Infra-red Output Unit

· The Infra-red Output Unit mounts to a standard single gang wall plate

With Scene Master a user can access up to five lighting scenes (switching/dimming

patterns) plus a Master-Off scene at the press of a button. Other features include:

· Scene Master has the ability to ‘learn’ lighting scenes set by the user

· The lighting system can be set up so that any scene can be recalled from

any switch connected to C-Bus

· Scene Master comes with a credit card sized, hand held infra-red remote

control unit

· Scene Master can be used to control any combination of C-Bus lighting groups

· Scene Master can control up to 33 groups of lighting

C-Bus Infra-red Output Unit

C-Bus Scene Master for total control

Dimming fluorescent lighting analogue control via a 0-10Vdc has been popular

for over 10 years now, but it has limitations. The ballast circuit still needs to be

switched on and off as the 0-10V analogue signal can not be used to switch

the luminaire. The 0-10V signal is also affected by volt drop, so only limited

runs were possible without signal amplification.

C-Bus DSI Gateway

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Sem comentários

Clipsal C-Bus2 Manual de Serviço Página 6