Clipsal C-Bus Especificações Página 22

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 64
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 21
C-BUS TRAINING MANUAL - VOL 1
22
6.0 C-Bus Power Supplies
The two-wire connection between C-Bus units serves two purposes. It is the communication medium
through which on and off signals are sent between inputs and outputs. It also carries a 36Vd.c. supply
to power the electronics in C-Bus units.
6.1 Voltage and Electrical Characteristics
The C-Bus power supply is isolated from the mains supply by at least 3kV. It achieves this isolation
using a double wound transformer. The output voltage is capped at 36V. C-Bus units that connect to
both mains and C-Bus supplies use transformers or opto-isolators to achieve isolation.
To achieve successful communication across the bus, power supplies must have the correct electrical
characteristics. For this reason only C-Bus power supplies are suitable for use in a C-Bus installation.
6.2 Short Circuit and Overload Protection
The internal circuitry of the power supply will react if:
• the bus conductors are shorted together
• too many C-Bus units are connected to a supply
• a C-Bus unit is incorrectly connected.
In all cases the power supply will limit the amount of current that flows to a safe level, ensuring that
neither it nor any other C-Bus unit is damaged.
6.3 Over Voltage Protection
It is recommended that sufficient over voltage and lightning protection be fitted, particularly in areas
where there is a high incidence of lightning strikes. The Clipsal 970 Series may be useful for this
purpose.
6.4 Multiple Power Supplies
Where the number of C-Bus units used on a system exceeds the capability of a C-Bus power
supply, additional power supplies are connected to increase capacity. In larger installations the
power supplies are best distributed around the system, to minimise voltage drop across the C-Bus
conductors. On any one C-Bus network, the combined power from the power supplies should not
exceed 2A, as this would exceed the current handling capability of the Cat-5 cable.
Vista de página 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Comentários a estes Manuais

Sem comentários