Clipsal C-Bus Manual de Instruções descarregar pdf (Página 48)

C-Bus™ Basic Programming 1250SM0904R10/09

C-Bus™ Products Training Course 10/2009

The source of this functionality is the ability to assign a load (such as a

light), with a controller (such as a wall switch), by touching the two units one

after the other. This is done while the C-Bus network is in Learn Mode.

NOTE: Learn Mode can be disabled from the C-Bus Toolkit Software to

protect the programming of the network.

Entering and Exiting Learn Mode

To enter learn mode, please follow the steps below.

1) Find any Learn Mode output unit.

2) Press and hold down any of the local toggle buttons on any output

units for 15 seconds. The Unit and C-Bus LEDs will then begin to flash

alternately.

NOTE: The Unit and C-Bus indicators may initially flash together for up to

20 seconds before flashing alternately. Various network parameters are

initialised during this time period.

To exit Learn Mode, please follow the steps below.

1) On any of the output units, press and hold down any of the local

toggle buttons for 2 seconds.

2) The Unit and C-Bus LED should now be on solid.

NOTE: As a result of entering Learn Mode, the C-Bus clock will then have

been successfully enabled on that particular output unit.

If Learn Mode has not been exited successfully within 10 minutes, all units

will resume normal operation without storing any changes.

Selecting Output Channels

While in Learn Mode, the local toggle buttons on output units can be

pressed. The selected load will be switched on and the appropriate indicator

will light up on the output unit. Multiple loads may be selected, across any

C-Bus output units.

Selecting Wall Switch Buttons

Once the loads have been selected, the user may choose one or more input

units to control those loads. Select the input switch or switches that are

required to control the loads.

If you make a mistake simply press the button again to deselect it, and

remove it from the current Learn operation.

The simplest association is one involving a single switch and a single load.

This would be achieved by the following steps:

1) Enter Learn Mode.

2) Select a channel on a C-Bus output unit.

3) Select a button on a wall switch input unit.

4) Exit Learn Mode.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 147 148

Sem comentários

Clipsal C-Bus Manual de Instruções Página 48