Clipsal C-Bus2 Especificações descarregar pdf (Página 64)

C-BUS TRAINING MANUAL - VOL 2

Function Action

Ramp Off The output level is ramped to the minimum level and then switched off.

The ramp rate is set by the 'Ramp 2' parameter (Global tab). This function

cannot be interrupted by the End Ramp function. A RAMP TO LEVEL

message is transmitted over the C-Bus Network.

Ramp Recall 1 The output level is ramped up or down (depending on the current level),

to the level stored in the Recall 1 memory location (Blocks tab). The ramp

rate is set by the 'Ramp 2' parameter (Global tab). This function cannot

be interrupted by the End Ramp function. A RAMP TO LEVEL message is

transmitted over the C-Bus Network.

Toggle If the output is currently off, it is set to the maximum level. Otherwise it is

switched off. An ON or OFF message is transmitted over the

C-Bus Network.

On Key If the output is off, it is set to the maximum level. Otherwise no action is

taken. An ON message may be transmitted over the C-Bus Network.

Off Key If the output is not off, it is switched off. Otherwise no action is taken.An

OFF message may be transmitted over the C-Bus Network.

End Ramp The ramping action initiated by a Downcycle, Down Key or Up Key function

is terminated. This allows an output to be set at an intermediate level. A

RAMP TO LEVEL message is transmitted over the C-Bus Network.

Table 5 – Functions which can be assigned to a button

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 119 120

Sem comentários

Clipsal C-Bus2 Especificações Página 64