Clipsal C-Bus2 Especificações descarregar pdf (Página 88)

C-BUS TRAINING MANUAL - VOL 2

4.0 Setting the Time

C-Bus

DLT input units contain a clock. The time is displayed at the base of the display when the

clock is enabled and the time has been set. You can set the time from the DLT unit, or from certain

other control units such as the C-Bus Colour Touch Screen. Setting the time on a DLT enables the

clock on that unit. It also sets the time on other C-Bus units, which have their clocks enabled and

reside on the same C-Bus Network.

The illustration shows how to set the time on a DLT unit:

• Hold down the fth (bottom-most) button for 10 seconds, until the display changes to time

set mode.

• Adjust the time. Press the Select (top) button to select which time property to adjust (hour

or minute). The + and – (second and third) buttons increment and decrement the selected

time property. Note that the time is displayed in 24-hour format, where 14:00 is equivalent

to 2:00 pm.

• Press the OK (bottom-most) button to exit clock set mode.

You will need to set the time again after a power failure. This may not be necessary if a control unit

capable of restoring the time is present on the C-Bus Network (such as the C-Bus Colour Touch

Screen).

Figure 9 - Setting DLT Clocks

NOTE: You will need to set the time again after a power failure. This may not be

necessary if a control unit capable of restoring the time is present on the C-Bus

Network (such as the C-Bus Colour Touch Screen).

Hold down the fifth button

to enter time set mode

Select which time property

to adjust (hour or minute)

Increment the selected

time property

Decrement the selected

time property

Press OK when finished

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 119 120

Sem comentários

Clipsal C-Bus2 Especificações Página 88